Today we’re sharing a colorful
Here’s what you’ll need for your necklace:
- 18″ cotton rope
- 24″ gold chain
- Assorted embroidery floss
- (4) wire pins with loops
- (4) 1/4″ jumprings
- Embroidery needle (not pictured)
Begin by cutting a 12″ piece of rope and tie the end of the first embroidery floss color 2/3 of the way through the rope piece as shown above. Tie it in a double knot so it stays secure.
Next, position the tail to the right and begin wrapping the floss over the tail, around and around until you have wrapped about an inch of the rope. Tie the end of the pink floss and leave an inch long tail.
Start your next color, in my case, yellow. Tie the yellow around the rope so that it is flush up against the pink. Wrap the yellow around its own tail as well as the previous one. Tie a knot at the end and do the a couple more colors in the same manner until you have about 4 inches covered.
Tie the navy blue floss at the bottom of the green section and then fold the rope in half and wrap it around both sections of the rope, as shown above. Do this for about 3/4 of an inch.
Tie a knot at the end and then use an embroidery needle to stick the tail back up through the middle of the two pieces of rope. Then trim the end so it isn’t visible.
Cut the bottoms of the rope so they are the same length, leaving about 3 inches of rope on each end.
Unwrap the rope so that it becomes individual threads instead of thick ropes, as shown above.
Next, cut a 6 inch piece of rope and wrap one pin around the end, positioning the loop at the end of the rope. Then begin wrapping the navy blue embroidery floss around and around.
Before you get too far, wrap another pin around the middle and one at the other end. Continue wrapping the navy floss around until you get to the other end.
Tie a knot and use the embroidery needle to tuck the tail up through the rope end and trim the excess.
Put a jumpring around the top of the tassel and attach it to the loop that is sticking out of the middle of the navy covered rope. Attach the gold chain to the ends of the navy covered rope with jumprings, and that’s it! You’re ready to rock your stylish new necklace.
This project is fun because you can really get creative with the colors, and also with the metallic elements – try silver, or even rose gold.
You can also vary the width of the colored sections, or even make them uneven. The sky’s the limit… just remember to have fun with it. Happy crafting everyone!